IT RUNS!!

The past week has been all about finishing all the hookups. Brake bleeding, hot wiring the coil and fuel pump, throttle cable hook up, add fluids, rob chain off the '35 Sports, exhaust and seats. The first big thing is to get oil pressure; I never crank a new engine until I know I have oil pressure. Well I didn't have any. Drop the pan and remove the pump and check it; was OK. Next thing is the valve cover gasket failure so remove carbs and manifolds and remove the side cover. THERE'S YOUR PROBLEM.

The Aquaplane side cover won't work on an E93 block and may not work on an E100 or they are only to be used with a fully modified oil system. The inside of the cover is machined away and won't seal off the oil gallery. I could have easily lost a new engine with that. Here you can see the original next to the Aquaplane.

That finally worked out it was time to crank it up.
First startup

Well that went well so why not take a drive.
First drive
What a great day!!

HOOK UPS

Now hooking everything up. The throttle pedal had a broke return spring so that had to be removed and fixed. Manifolds are all on with exhaust wrapped with fiberglass tape and sealed with high temp silicone paint. Rad fitted and hoses secured. The exhaust won't fit up without some bending so a trip to the muffler shop is in the future. It fits well enough for test firing. I have to add fluids and fuel pump and bleed the brakes to be ready for a test drive. Hopefully by next weekend.

IT'S IN THE CAR!!!

This was quite easy and took about an hour by myself. Really exciting to see it get to this point. Lots of stuff to do to get it running but that won't be too far away.

I did have to re-drill the holes for the mounting plates and the engine sits about 1/2" high so the hand crank won't fit. The only way I see to fix this is to raise the gearbox up about 3/4" so as to tilt the front of the engine down. For some reason the bellhousing crossmember is holding the engine up.

ENGINE READY

The engine is buttoned up and ready to install. Should happen this week.

I was able to separate the scuttle from the rear body so I set it on the chassis for a dry fit. That will also make the body work easier.

BRAKES

The juice brakes are now all plumbed up. The master cylinder has several fluid cans; direct or remote mounting. I'll wait until the engine is in to decide which way to go.